An off-body pass and a pass in the final housing are two different conditions. Wearable antenna design at NexPCB starts from the space inside the housing and the bands the device has to cover. Off-body is the antenna away from the body. It is not the same statement as the antenna sitting outside the housing.
The antenna has to live in the housing and still cover the bands the product needs. When the space is short, the antenna form, the layout, and the match are reviewed before a band or a function is removed. Removing a band is one outcome of that review. It is not the first move. A band that stays is written as the requirement the layout uses.
In a small device the antenna usually covers more than one band, and it is built against the housing rather than given a flat patch of its own. The keep-out around it is part of that shape. On a wearable program the housing geometry and the antenna placement are designed together, including the radio keep-out.
| Still open | What can move the result | What the bench pass already answered |
|---|---|---|
| The body | Tissue and the way the device is worn | The antenna away from the body. Off-body is not a result taken outside the housing |
| The housing | The material, the dielectric, the loss, and the match | A result taken before the final housing is fitted. That condition is separate from off-body |
| The wearing position | Wrist, chest, or another site | One position on the bench |
A pass on the bench answers the antenna away from the body. The final housing and the place the device is worn can each move the result after that pass. The record names which condition is still open before the bench result is treated as the worn result. A display arm in the photograph shows a wearing position. It is not an RF body model.
The off-body condition and the final-housing condition are measured separately when this build takes those two measurements.
A new housing material can change the dielectric, the loss, and the match. The retest follows what changed. A design tool that places the antenna changes the drawing. It does not replace the measurement.
No. Off-body is the antenna away from the body. The final housing and the wearing position are separate conditions.
The retest follows what the material changes: the dielectric, the loss, and the match. A change that can move the worn result keeps that check.
Bring the bands, the housing space the antenna may use, and the keep-out you already expect. If an off-body result exists, bring it separately from any on-body result. Start at our project inquiry form.