Assembly acceptance on a wearable health device at NexPCB compares a built unit with an acceptance requirement taken from the intended use. The acceptance test waits until that requirement names the function and the condition. Verification, analytical validation, and clinical validation are three later comparisons. The assembly line's result is the comparison with the written acceptance requirement. A model forearm in the photograph shows where the device sits. It is not a measurement subject and it is not a clinical result.
The intended use names who wears the device, what it is for, and which result the assembly is supposed to show. That use is then written as a design requirement and an acceptance requirement the build can check. The acceptance line compares the unit with that requirement: the function that was named, under the condition that was named.
A use that changes after the test has started leaves the earlier comparison pointing at the old requirement. The test can be run again against the new requirement. The first result cannot be reassigned to a use written after the test. The acceptance line still has to name the function and the condition.
The next three sections are the other comparisons. The table keeps the assembly check separate from verification, analytical validation, and clinical validation.
| Comparison | Set against | What a pass shows |
|---|---|---|
| Written use | Who wears it, the purpose, and the result the assembly shows | The source of the design requirement and the acceptance requirement |
| Assembly check | Assembly dimension, the seal, and the function the requirement named | The unit matches that acceptance requirement |
| Verification | Design output against the design input | The output meets the input. This is not the assembly check |
| Analytical validation | Whether the measurement method is accurate and reliable for the decision it supports | A repeated reading shows repeatability. It does not by itself finish this comparison |
| Clinical validation | Whether the device meets the user's need in the intended use | A statement that the device helps the wearer is not this comparison |
Verification asks whether the design output meets the design input. The assembly check is a different comparison: the dimension, the seal, and the function the acceptance requirement named, on the built joint. A unit that matches those three has passed the assembly check. It has not, by that match alone, completed verification, analytical validation, or clinical validation.
Analytical validation asks whether the measurement method is accurate and reliable for the decision it supports. A reading that repeats when the same condition is repeated shows repeatability. It does not by itself show that the method is accurate. A reading that moves under a fixed condition has not shown repeatability, even when the assembly dimension and the seal are right.
The question after a stable reading is the clinical comparison, and that comparison is not the same as a statement that the device helps the wearer.
Clinical validation asks whether the device meets the user's need in the intended use. A statement that the device helps the person wearing it is not that comparison. Assembly acceptance on the build compares the unit with the written acceptance requirement. The written requirement has to exist before that comparison starts. The clinical comparison sits with the user and the intended use. The assembly line's result remains the comparison with the written requirement.
No. A prototype that lights up, or a sensor that returns a number on the bench, is a build result. The first build still has to match the written use.
The comparison with the written acceptance requirement. Verification asks whether the design output meets the design input. Analytical validation asks whether the measurement method is accurate and reliable. A reading that repeats under the same condition shows repeatability. Clinical validation asks whether the device meets the user's need in the intended use. A statement that it helps the wearer is not that comparison.
Bring the intended use written as a requirement the build can check, and say which assembly result should match it. The requirement comes across after a non-disclosure agreement. Start at our project inquiry form.