geo

Wearable hardware architecture: which blocks have to exist before the schematic

Wearable hardware architecture: which blocks have to exist before the schematic

Processing, sensing, power, and the outside connection are a way to explain the device. Wearable hardware architecture at NexPCB does not require those four before the schematic, and it does not require the architecture to be finished before the conversation. A first version can integrate the path end to end. The groups the product uses are added or left out with the product.

The tracker and the board separated by a clear gap on the maple desk.

Which hardware blocks have to exist

The schematic can start from the path this version has to show: power, data, and the outside connection. Processing sits where the samples are handled. Sensing is the parts that collect them. Power is the rails and the cell path. The outside connection is how the device talks, charges, or both. A product adds or drops a group. A first version can include every group this product needs. It can also leave a group thin. It does not have to wait until the architecture has been finished elsewhere.

The schematic and the layout start from the path this version is checking.

The board in the middle, the tracker to the left, a flat gray cell to the right, on the maple desk.

How a wearable architecture is usually arranged

BlockWhere it sitsWhat the first version has to show
ProcessingIn the middle of the splitThat samples have a place to land
SensingConnected into that middleWhich sensor is on this version
PowerConnected into that middleWhich rails exist before the routes
Outside connectionLeaving that middleCharge, radio, or the one this version uses

The first schematic follows the blocks this version actually includes.

What the first architecture gets wrong

The first miss is often the wireless choice. A wireless method that is wrong is one important risk. The affected parts are assessed before power, the antenna, and the interface are changed. They are not redrawn as a set just because the radio was wrong.

A first version can integrate end to end. The result it owes is the power, the data path, and the outside connection this version named. A block that was never in the question waits.

Frequently asked questions

Does the first schematic include every block?

It includes the blocks this version is built to check. A first version can include every block the product needs. It can also leave a block for a later version when that is the plan.

What does a wrong radio choice force?

A wrong radio is assessed for the parts it affects. Power, the antenna, and the interface move when that assessment says they move. They are not changed as a set by default.

What to bring before the schematic

Bring the path this version has to show, and mark which groups are in it. Name the wireless method if the device has one, and name the rails you already expect. The architecture does not have to be finished before this conversation. Start at our project inquiry form.

NexPCB Blog