LAUNCH

NexPCB Blog: qc

Pros and Cons of an Immersion Silver PCB Surface Finish

Immersion Silver, also known as IM silver, IMag, or ENIAg, among its other names, refers to the...

Troubleshooting eMMC Failures

Everything looks fine, so why are your eMMCs failing? How do you track down the issue?

We...

20 Common Quality Issues in Plastic Production

If you are dealing with electronic products development, it's very likely that you are dealing...

How to Avoid Short Shots in Your Plastic Production

Creating plastic casing using the injection molding process is more and more common during the...

How To Avoid Sink Marks In Your Plastic Production

 

After analyzing the short shot issue, We decided to come back to another problem you can...

Step-by-Step Guide to Quality Control

Many people think that QC is something that is done at the end of production before things are...

How Quality Control Has an Impact on Different Production Stages

There are a large number of variables that dictate good aesthetic and functional qualities to a...

7 Mistakes Contract Manufacturers Make During the NPI Process

Most of the time, hardware startups are faced with the challenge of New Product Introduction...

Voids In Solder Joaints

Voids in solder joints are a significant problem facing industrial products, especially in power...

SMT quality management

With the transition of product-oriented to more market-oriented (aka customer-oriented) business...

SMT BGA Solder Joint Slice Analysis

With the continued shrinking of electronic components and the addition of many BGAs to...

How to Avoid Color Streaks and Gloss Difference in your Plastic Production

Today marks the last of our posts about common issues in your plastic production. This post...

How to Avoid Silver Streaks and Splay Marks in Plastic Injection Molding

Today we are back with two new common issues in plastic production. If you are new here, this...

How to avoid Black Specs, Ejector Pin Marks and Drag Marks in your Plastic Production

If you've been following us, you might have noticed that avoiding quality issues in your plastic...

How to Avoid Cracks and Burn Marks in your Plastic Production

After analyzing the Short Shot and 10 other plastic production issues, we decided to come back...

How to Avoid Sink Marks in Your Plastic Production

This post is the 11th article in our series about common issues that you can encounter during...